Here’s how it works: 

1. Make sure the rise setting works for your baby.  For newborn and smaller babies, adjust the rise by snapping down the front of the diaper to the appropriate setting. Once you have adjusted the rise, you can leave it snapped down even after it is soiled, in the washer and the dryer too… no need to reset it each time. Next add an insert.

Tip: After the newborn stage, push the hooks to the neighboring loop to put them out of the way for the next baby.

2. Choose from the two front hook settings to fit your child.  Inner hooks for small babies (b), outer hooks for bigger babies(a).

3. Snugly latch the hooks through the eyelets along the back of the diaper. This may take a bit of practice, but once you have done it a few times some say it’s easier than a snap or velcro diaper!

Tip: When latching and unlatching the hooks through the eyelets it will work a bit smoother if you lightly push the hook towards the diaper

4. And finally, wrap the wings around and fasten them snugly in the center front eyelets.